A rotary kiln or dryer that is slightly out of alignment can run for months without obvious trouble. Meanwhile it wears the riding rings and rollers, overloads the drive and flexes the shell, and a flexing shell cracks the refractory lining inside it.
What alignment covers
- Shell straightness along its length
- Drum slope, matched to the design
- Support roller positions and skew, so the drum runs without excessive thrust
- Full-face contact between riding rings and rollers
- Girth gear and pinion mesh and runout
Signs of misalignment
- Uneven or fast wear on riding rings and rollers
- The drum riding hard against the thrust rollers
- Noise, vibration or rising drive current
- Repeated cracking or loose bricks in the same zone of the lining
- Hot spots on the shell
Why it matters for the lining
Refractory bricks and castables are made to handle heat, not a shell that bends on every turn. Ovality and misalignment flex the shell and work the lining loose, so bricks crack or fall out long before they are worn. Checking alignment and shell ovality before relining protects the money spent on new refractory.
Good practice
- Check alignment after erection and at every major shutdown
- Measure shell ovality near the riding rings
- Record roller adjustments instead of adjusting by feel
- Reline only after shell and alignment problems are corrected
JISPL erects and aligns rotary kilns and dryers with our own team and combines alignment checks with relining during shutdowns, so the machine and its lining are handed back in step.
Send us the details and get a quick quotation or a site visit.